![]() With the unit on, long press DISP to display clock time. ![]() The reset button is located on the front panel. Press the RESET button to reset the unit back to the factory settings if abnormal operation occurs. Insert a 3.5mm cable in the unit's front AUX port. Press again to resume listening at the previously selected volume. Modes of operation are shown in the display.Īdjust volume using the volume knob (00-40). Press MODE to select between Radio, USB, Bluetooth, AUX. The unit uses one 10 amp AGC fuse located beside the Heat Sink Control Locations Using an incorrect fuse could damage the radio. YELLOW | Memory: Connect to battery circuit or constant 12 volt source.įUSE: When replacing the fuse, make sure new fuse is the correct type and amperage. RED | Accessory: Connect to existing ignition circuit or switched 12 volt source. Insulate wire if not used.īLACK | Ground: Connect to vehicle chassis ground. Remove the plastic caps and use the removal keys to remove the unit.īLUE | Remote Turn-On: Connect to amplifier or power antenna.Connect all wiring harnesses and slide the head unit into the mounting sleeve until it clicks into place.Bend multiple mounting tabs around the mounting sleeve until the mounting sleeve is secure. ![]() Insert the mounting sleeve into the installation kit or dashboard.Mounting the Head Unit: Typical DIN mounting Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.Consult a qualified technician for instructions. Please read entire manual before installation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |